823
Chapter 52
GARP VLAN Registration Protocol
Commands
The GARP VLAN registration protocol commands are summarized in
Table 74 and described in detail within the chapter.
Table 74. GARP VLAN Registration Protocol Commands
Command Mode Description
“CONVERT DYNAMIC VLAN” on
page 825
VLAN
Configuration
Converts dynamic GVRP VLANs and
port assignments to static.
“GVRP APPLICANT STATE ACTIVE”
on page 826
Global
Configuration
Enables GIP on the switch.
“GVRP APPLICANT STATE
NORMAL” on page 827
Global
Configuration
Disables GIP.
“GVRP ENABLE” on page 828 Global
Configuration
Enables GVRP.
“GVRP REGISTRATION” on
page 829
Port Interface Set a port’s GVRP status.
“GVRP TIMER JOIN” on page 830 Global
Configuration
Sets the GARP Join Timer.
“GVRP TIMER LEAVE” on page 831 Global
Configuration
Sets the GARP Leave Timer.
“GVRP TIMER LEAVEALL” on
page 832
Global
Configuration
Sets the GARP Leave All timer.
“NO GVRP ENABLE” on page 833 Global
Configuration
Disables GVRP on the switch.
“NO GVRP TIMER JOIN” on page 834 Global
Configuration
Disables the GARP Join Timer.
“NO GVRP TIMER LEAVE” on
page 835
Global
Configuration
Disables the GARP Leave Timer.
“NO GVRP TIMER LEAVEALL” on
page 836
Global
Configuration
Disables the GARP Leave All timer.
“PURGE GVRP” on page 837 Global
Configuration
Disables GVRP on the switch and
returns the timers to their default
values.