AT-9000 Switch Command Line User’s Guide
959
Disabling 802.1x Port-Based Network Access Control on the Switch
To disable 802.1x port-based network access control on the switch so that
the ports forward packets without authentication, go to the Global
Configuration mode and enter the NO AAA AUTHENTICATION DOT1X
DEFAULT GROUP RADIUS command. Here is the command:
awplus> enable
awplus# configure terminal
awplus(config)# no aaa authentication dot1x default group
radius
The switch retains the configuration settings of the authenticator
ports when 802.1x port-based network access control is deactivated.
Authenticator ports will also not forward traffic of connected hosts
until the dot1x interface configuration has also been negated.
To Next Page
Loading...
Need help?
General
