AT-9000 Switch Command Line User’s Guide
551
UPLOAD IMAGE REMOTELIST
Syntax
upload image remotelist
Parameters
None
Mode
Global Configuration mode
Description
Use this command to download the management software on the
command switch to other switches in an enhanced stack. For background
information on enhanced stacking, refer to Chapter 21, “Enhanced
Stacking” on page 409. For instructions on how to use this command, refer
to “Uploading the Management Software from the Command Switch to
Member Switches” on page 429.
Downloading new management software causes the switch to reset.
The switch does not forward network traffic while it writes the new
software to flash memory and initializes the software. Do not
interrupt the process by resetting or power cycling the switch. Some
network traffic may be lost.
Example
The following example downloads the management software of the
command switch to other switches:
upload image remotelist
To Next Page
Loading...
Need help?
General
