Allied Telesis AT-9000 Series - Purge

Chapter 10: Port Parameter Commands
216
PURGE
Syntax
purge
Parameters
None
Mode
Port Interface mode
Description
Use this command to restore the default settings to these port parameters:
 Enabled status (NO SHUTDOWN)
 Description
 Speed
 Duplex mode
 MDI/MDI-X
 Flow control
 Backpressure
 Head of line blocking threshold
 Backpressure cells
Example
This example restores the default settings to ports 5, 6 and 12:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.5,port1.0.6,port1.0.12
awplus(config-if)# purge