Allied Telesis AT-9000 Series - Telnet

Chapter 83: Telnet Client Commands
1370
TELNET
Syntax
telnet ipv4_address [ port ]
Parameters
ipv4_address
Specifies the IPv4 address of a remote device you want to manage
using the Telnet client on the switch. You can specify just one
address.
port
Specifies the protocol port number of the Telnet client. The default
value is 23.
Mode
Privileged Exec mode
Description
Use this command to start Telnet management sessions on network
devices that have IPv4 addresses. You can manage just one remote
device at a time.
Note
This command is available from local and Telnet management
sessions.
Example
This example starts a Telnet management session on a network device
that has the IP address 132.154.67.134:
awplus> enable
awplus# telnet 132.154.67.134