Allied Telesis AT-9000 Series User Manual

AT-9000 Switch Command Line User’s Guide
237
SHUTDOWN
Syntax
shutdown
Parameter
None
Mode
Port Interface mode
Description
Use this command to disable ports. Ports that are disabled do not forward
traffic. You might disable ports that are unused to secure them from
unauthorized use or that are having problems with network cables or their
link partners. The default setting for the ports is enabled.
To reactivate a port, refer to “NO SHUTDOWN” on page 211.
Confirmation Command
“SHOW INTERFACE” on page 221
Example
This example disables ports 15 and 16:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.15,port1.0.16
awplus(config-if)# shutdown

Allied Telesis AT-9000 Series Specifications

General

Brand	Allied Telesis
Model	AT-9000 Series
Category	Switch
Language	English