Allied Telesis AT-9000 Series - Enabling the Telnet Server

AT-9000 Switch Command Line User’s Guide
1357
Enabling the Telnet Server
To enable the server, go to the Global Configuration mode and issue the
SERVICE TELNET command. Here is the command:
awplus> enable
awplus# configure terminal
awplus(config)# service telnet
Once the server is started, you can conduct remote management sessions
over your network from Telnet clients, provided that the switch has a
management IP address. For instructions on how to start a remote Telnet
management session, refer to “Starting a Remote Telnet or SSH
Management Session” on page 68.