AT-9000 Switch Command Line User’s Guide
987
DOT1X PORT-CONTROL FORCE-UNAUTHORIZED
Syntax
dot1x port-control force-unauthorized
Parameters
None
Mode
Port Interface mode
Description
Use this command to configure the ports to the 802.1x authenticator role,
in the unauthorized state. Although the ports are in the authenticator role,
the switch blocks all traffic on the ports. For background information, refer
to “Operational Settings for Authenticator Ports” on page 942.
Confirmation Command
“SHOW AUTH-MAC INTERFACE” on page 995 or “SHOW DOT1X
INTERFACE” on page 1000
Example
This example sets ports 1.0.7 and 1.0.24 to the authenticator role, in the
force-unauthorized state:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.7,port1.0.24
awplus(config-if)# dot1x port-control force-unauthorized
To Next Page
Loading...
