AT-9000 Switch Command Line User’s Guide
259
NO POWER-INLINE DESCRIPTION
Syntax
no power-inline description
Parameters
None
Mode
Port Interface mode
Description
Use this command to delete PD descriptions from the ports.
Confirmation Commands
“SHOW POWER-INLINE” on page 274
“SHOW POWER-INLINE INTERFACE” on page 279
“SHOW POWER-INLINE INTERFACE DETAIL” on page 280
Example
The following example deletes the PD description from port 5:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.5
awplus(config-if)# no power-inline description
To Next Page
Loading...
