Allied Telesis AT-9000 Series - No Arp (Ip Address)

AT-9000 Switch Command Line User’s Guide
1195
NO ARP (IP ADDRESS)
Syntax
no arp ipaddress
Parameters
ipaddress
Specifies the IP address of a static ARP entry.
Mode
Global Configuration mode
Description
Use this command to delete a static ARP entry from the ARP cache. Static
ARP entries do not expire, and you must remove them manually. This
command can delete only one ARP entry at a time.
Confirmation Command
“SHOW ARP” on page 1196
Example
The following example deletes the static ARP entry of the IP address
192.168.1.2:
awplus> enable
awplus# configure terminal
awplus(config)# no arp 192.168.1.2