AT-9000 Switch Command Line User’s Guide
395
Displaying the MAC Address Table
To view the aging time or the MAC address table, use the SHOW MAC
ADDRESS-TABLE command in the Privileged Exec mode. Here is its
format:
show mac address-table [interface
port
]|[vlan
vid
]
An example of the table is shown in Figure 83.
Figure 83. SHOW MAC ADDRESS-TABLE Command
The columns in the window are described in “SHOW MAC ADDRESS-
TABLE” on page 406.
This example of the command displays the entire MAC address table:
awplus# show mac address-table
This example displays the MAC addresses learned on port 2:
awplus# show mac address-table interface port1.0.2
Aging Interval: 300 second(s)
Switch Forwarding Database
------------------------------------------------------------
VLAN Port MAC Fwd
------------------------------------------------------------
1 1.0.5 0011.2495.53f8 forward dynamic
1 1.0.5 0023.6c90.08b9 forward dynamic
1 1.0.5 0024.36a0.1551 forward dynamic
1 1.0.5 0025.00d7.8908 forward dynamic
1 1.0.5 0050.50de.ad01 forward dynamic
.
.
.
------------------------------------------------------------
Total Number of MAC Addresses: 121
Multicast Switch Forwarding Database
Total Number of MCAST MAC FDB Addresses: 1
---------------------------------------------------------------------
VLAN MAC Port Maps (U:Untagged T:Tagged)
---------------------------------------------------------------------
1 01:00:51:00:00:01 Static U:18-24
T:
To Next Page
Loading...
Need help?
General
