Chapter 70: LLDP and LLDP-MED Commands
1166
Example
The following example displays general LLDP settings:
awplus# show lldp
Hold-time Multiplier The holdtime multiplier. The transmit
interval is multiplied by the holdtime
multiplier to give the Time To Live (TTL)
value that is advertised to neighbors.
Reinitialization Delay The re-initialization delay. This is the
minimum time that must elapse after
LLDP has been disabled before it can be
initialized again.
Tx Delay The transmission delay. This is the
minimum time interval between
transmissions of advertisements due to
changes in LLDP local information.
Total Neighbor Count Number of LLDP neighbors the switch has
discovered on all its ports.
Neighbors table last
updated
The time since the LLDP neighbor table
was last updated.
Table 105. SHOW LLDP Command (Continued)
Field Description
To Next Page
Loading...
