Chapter 9: Port Parameters
174
This example sets the speeds of ports 11 and 17 to 100Mbps:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.11,port1.0.17
awplus(config-if)# speed 100
This example configures port 1 to half-duplex:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.1
awplus(config-if)# duplex half
This example configures ports 2 to 4 to 10 Mbps, full-duplex:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.2-port1.0.4
awplus(config-if)# speed 10
awplus(config-if)# duplex full
This example sets the speed on port 15 to Auto-Negotiation and the
duplex mode to half duplex:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.15
awplus(config-if)# speed auto
awplus(config-if)# duplex half
This example sets the speed on port 23 to 100 Mbps and the duplex mode
to Auto-Negotiation:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.23
awplus(config-if)# speed 100
awplus(config-if)# duplex auto
For reference information, refer to “SPEED” on page 239 and “DUPLEX”
on page 200.
To Next Page
Loading...
