Chapter 12: Power Over Ethernet Commands
276
Example
This example displays PoE information about the switch and ports:
awplus# show power-inline
Oper The PoE operating status of the port. The possible
status are listed here:
Powered: The port is transmitting power to the
PD.
Denied: The port is not transmitting power to
the PD because the switch has reached its
maximum power capacity.
Off: PoE is disabled on the port.
Fault: The switch is exceeding the total
available power.
Test: The port is in a test mode.
Power The port’s current power consumption in milliwatts
(mW).
Device The port’s PD description. This parameter is set
with “POWER-INLINE DESCRIPTION” on
page 267.
Class The PD’s class PD. See “PD Classes” on page 244
for details.
Max (mW) The port’s maximum power limit in milliwatts (mW)
and how the limit was set. The methods are listed
here:
[U]: The power limit was set with “POWER-
INLINE MAX” on page 269.
[L]: The power limit was supplied by LLDP.
[C]: The power limit was set according to the
PD’s class.
Table 23. SHOW POWER-INLINE Command (Continued)
Field Description
To Next Page
Loading...
Need help?
General
