Chapter 12: Power Over Ethernet Commands
282
Examples
This example displays PoE information for port 1:
awplus# show power-inline interface port1.0.1 detail
This example displays PoE information for ports 7 to 10:
awplus# show power-inline interface port1.0.7-port1.0.10
detail
Detection of
legacy devices
The status of support for a legacy PD on the port:
Enabled: The port supports legacy devices.
Disabled: The port does not support legacy
devices.
Support for legacy devices is enabled with
“POWER-INLINE ALLOW-LEGACY” on page 266
and disabled with “NO POWER-INLINE ALLOW-
LEGACY” on page 258.
Powered pairs The twisted pairs used to transfer power to the PD.
This parameter is not adjustable. The value is one
of the following:
Data
Spare
Table 25. SHOW POWER-INLINE INTERFACE DETAIL Command
Field Description
To Next Page
Loading...
