Chapter 44: STP Commands
664
“SPANNING-TREE PORTFAST
BPDU-GUARD” on page 675
Port Interface Enables the BPDU guard feature on a
port so that the switch monitors edge
ports and disables them if they receive
BPDUs.
“SPANNING-TREE PRIORITY (Bridge
Priority)” on page 676
Global
Configuration
Assigns the switch a priority number.
“SPANNING-TREE Priority (Port
Priority)” on page 677
Port Interface Assigns a priority value to a port.
“SPANNING-TREE STP ENABLE” on
page 678
Global
Configuration
Enables STP on the switch.
Table 63. Spanning Tree Protocol Commands (Continued)
Command Mode Description
To Next Page
Loading...
