AT-9000 Switch Command Line User’s Guide
91
DO
Syntax
do
command
Parameter
command
Specifies the Privileged Exec mode command to perform.
Mode
Global Configuration mode
Description
Use this command to perform Privileged Exec mode commands from the
Global Configuration mode. You may use the command to perform some,
but not all, of the Privileged Exec mode commands. To view the available
commands, type a question mark “?” after the DO command.
Examples
This example displays all of the Privileged Exec mode commands you may
perform using the DO command in the Global Configuration mode:
awplus(config)# do ?
This example displays all of the available SHOW commands:
awplus(config)# do show ?
This example performs the SHOW INTERFACE command for port 4 from
the Global Configuration mode:
awplus(config)# do show interface port1.0.4
This example pings a network device:
awplus(config)# do ping 149.11.123.45
To Next Page
Loading...
