Allied Telesis AT-9000 Series - Page 965

AT-9000 Switch Command Line User’s Guide
965
“NO AUTH REAUTHENTICATION” on
page 992
Port Interface Removes reauthentication from
authenticator ports.
“NO AUTH-MAC ENABLE” on
page 993
Port Interface Deactivates MAC address-based
authentication on authenticator ports.
“NO DOT1X PORT-CONTROL” on
page 994
Port Interface Removes ports from the authenticator
role.
“SHOW AUTH-MAC INTERFACE” on
page 995
Privileged Exec Displays the parameter settings of
authenticator ports.
“SHOW AUTH-MAC
SESSIONSTATISTICS INTERFACE”
on page 996
Privileged Exec Displays the session status of the
authenticator ports.
“SHOW AUTH-MAC STATISTICS
INTERFACE” on page 997
Privileged Exec Displays the authentication statistics
of authenticator ports.
“SHOW AUTH-MAC SUPPLICANT
INTERFACE” on page 998
Privileged Exec Displays the supplicant state on
authenticator ports.
“SHOW DOT1X” on page 999 Privileged Exec Displays whether 802.1x port-based
network access control is enabled or
disabled on the switch and the IP
address of the RADIUS server.
“SHOW DOT1X INTERFACE” on
page 1000
Privileged Exec Displays the parameter settings of
authenticator ports.
“SHOW DOT1X STATISTICS
INTERFACE” on page 1001
Privileged Exec Displays EAP packet statistics on
authenticator ports.
“SHOW DOT1X SUPPLICANT
INTERFACE” on page 1002
Privileged Exec Displays the supplicant state on
authenticator ports.
Table 88. 802.1x Port-based Network Access Control Commands (Continued)
Command Mode Description