AT-9000 Switch Command Line User’s Guide
971
This example configures authenticator port 1.0.8 to the multi-host
operating mode, so that networks users can use the port after just one
user logs on:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.8
awplus(config-if)# auth host-mode multi-host
This example configures authenticator ports 1.0.12 and 1.0.13 to the multi-
supplicant operating mode, which requires that all networks users on the
ports log on:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.12,port1.0.13
awplus(config-if)# auth host-mode multi-supplicant
To Next Page
Loading...
