D-Link xStack DGS-3610 Series User Manual

DGS-3610 Series Configuration Guide Chapter 28 OSPF Routing Protocol Configuration
28-23
10.10.10.50 1 Full/DR 00:00:38 10.10.10.50 eth0/0
OSPF process 100:
Neighbor ID Pri State Dead Time Address I nterface
10.10.11.50 1 Full/Backup 00:00:31 10.10.11.50 eth0/1
DGS-3610# show ip ospf 1 neighbor
OSPF process 1:
Neighbor ID Pri State Dead Time Address: Interface
10.10.10.50 1 Full/DR 00:00:38 10.10.10.50 eth0
DGS-3610# show ip ospf 100 neighbor
OSPF process 100:
Neighbor ID Pri State Dead Time Address: Interface
10.10.11.50 1 Full/Backup 00:00:31 10.10.11.50 eth1
2. Show the OSPF interface status
The following message shows that the F0/1 port belongs to area 0 of the OSPF, and the
device ID is 172.16.120.1. The network type is ―BROADCAST‖-broadcast type. You must
pay special attention to the parameters such as Area, Network Type, Hello and Dead. If
these parameters are different from the neighbor, no neighborhood relationship will be
established.
DGS-3610# sh ip ospf interface fastEthernet 1/0
FastEthernet 1/0 is up, line protocol is up
Internet Address 192.168.1.1/24, Ifindex: 2 Area 0.0.0.0, MTU 1500
Matching network config: 192.168.1.0/24
Process ID 1, Router ID 192.168.1.1, Network Type BROADCAST, Cost: 1
Transmit Delay is 1 sec, State DR, Priority 1
Designated Router (ID) 192.168.1.1, Interface Address 192.168.1.1
Backup Designated Router (ID) 192.168.1.2, Interface Address 192.168.1.2
Timer intervals configured, Hello 10, Dead 40, Wait 40, Retransmit 5
Hello due in 00:00:04
Neighbor Count is 1, Adjacent neighbor count is 1
Crypt Sequence Number is 30
Hello received 972 sent 990, DD received 3 sent 4
LS-Req received 1 sent 1, LS-Upd received 10 sent 26
LS-Ack received 25 sent 7, Discarded 0
3. Show the information of the OSPF routing process
The following command shows the route ID, device type, area information, area summary,
and other related information.
DGS-3610# show ip ospf
Routing Process "ospf 1" with ID 1.1.1.1
Process uptime is 4 minutes
Process bound to VRF default
Conforms to RFC2328, and RFC1583Compatibility flag is enabled
Supports only single TOS(TOS0) routes
Supports opaque LSA
This router is an ASBR (injecting external routing information)
SPF schedule delay 5 secs, Hold time between two SPFs 10 secs
LsaGroupPacing: 240 secs
Number of incomming current DD exchange neighbors 0/5

D-Link xStack DGS-3610 Series Specifications

General

Brand	D-Link
Model	xStack DGS-3610 Series
Category	Switch
Language	English