To Next Page

To Previous Page

DGS-3610 Series Configuration Guide Chapter 6 Configuring Interfaces

6-15

Command

Function

DGS-3610(config-if)# ip address ip_address

subnet_mask {[secondary | tertiary |

quartus][broadcast]}

Configure the IP address and subnet mask.

To delete the IP address of an L3 interface, use the no ip address command in interface

configuration mode.

The no switchport operation cannot be performed on one member of L2 Aggregate Ports.

The following example shows how to set an L2 interface to routed port and assign an IP

address to it.

DGS-3610# configure terminal

Enter configuration commands, one per line. End with CNTL/Z.

DGS-3610(config)# interface gigabitethernet 2/1

DGS-3610(config-if)# no switchport

DGS-3610(config-if)# ip address 192.20.135.21 255.255.255.0

DGS-3610(config-if)# no shutdown

DGS-3610(config-if)# end

6.2.9.1 Configuring SVI

The section describes how to create an SVI and some related configuration of SVI.

You may create an SVI or modify an existing one by using interface vlan vlan-id.

Configuration of SVI:

Command

Function

DGS-3610(config)# interface vlan vlan-id

Enter SVI interface configuration mode.

Then, you can configure the attributes related to SVI. For detailed information, please refer

to the Configuring IP Single Address Route.

The following example shows how to enter interface configuration mode and how to assign

an IP address to SVI 100.

DGS-3610# configure terminal

Enter configuration commands, one per line. End with CNTL/Z.

DGS-3610(config)# interface vlan 100

DGS-3610(config-if)# ip address 192.168.1.1 255.255.255.0

DGS-3610(config-if)# end

6.2.9.2 Configuring Routed Ports

This section describes how to create Routed port and the related configuration of Routed

port.

D-Link xStack DGS-3610 Series User Manual

Other manuals for D-Link xStack DGS-3610 Series