D-Link xStack DGS-3610 Series User Manual

Chapter 6 Configuring Interfaces DGS-3610 Series Configuration Guide
6-16
You may create a Routed port by using no switchport after you have entered an interface in
interface mode.
Create one Routed port and assign an IP address to the ROuted port:
Command
Function
DGS-3610(config-if)# no switchport
Shut down the interface and then change it to L3
mode.
DGS-3610(config-if)# ip address ip_address
subnet_mask
Configure the IP address and subnet mask.
Caution
No layer switching can be performed through using switchport/ no
switchport when an interface is a member of an L2 Aggregate Port.
The following example shows how to set an L2 interface to Routed port and then assign an
IP address to it.
DGS-3610# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
DGS-3610(config)# interface fastethernet 1/6
DGS-3610(config-if)# no switchport
DGS-3610(config-if)# ip address 192.168.1.1 255.255.255.0
DGS-3610(config-if)# no shutdown
DGS-3610(config-if)# end
6.2.9.3 Configuring L3 Aggregate Ports
This section describes how to create an L3 Aggregate Port and some related configuration.
In the interface mode, you can use no switchport to change a L2 Aggregate Port to a L3
Aggregate Port:
Command
Function
DGS-3610(config-if)# no switchport
Shut down the interface and change it to L3
mode.
DGS-3610(config-if)# ip address ip_address
subnet_mask
Configure the IP address and subnet mask.
The following example shows how to create an L3 Aggregate Port and assign an IP address
to it.
DGS-3610# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
DGS-3610(config)# interface aggregateport 2
DGS-3610(config-if)# no switchport
DGS-3610(config-if)# ip address 192.168.1.1 255.255.255.0

D-Link xStack DGS-3610 Series Specifications

General

Brand	D-Link
Model	xStack DGS-3610 Series
Category	Switch
Language	English