Enterasys SecureStack C2

show multiauth
SecureStack C2 Configuration Guide 18-31
role.Whenapolicyroleisdynamicallyappliedtoaportastheresultofasuccessfully
authenticatedsession,the“authenticatedVLAN”ismapped tothepolicyrolesetintheFilter‐ID
returnedfromtheRADIUSserver.The“authenticatedVLAN”mayeitherbethePVIDoftheport,
ifthe
PVIDOverrideforthepolicyprofileisdisabled,ortheVLANspecifiedinthePVID
OverrideifthePVIDOverrideisenabled.
Commands
show multiauth
Usethiscommandtodisplaymultipleauthenticationsystemconfiguration.
Syntax
show multiauth
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐only.
For information about... Refer to page...
show multiauth 18-31
set multiauth mode 18-32
clear multiauth mode 18-32
set multiauth precedence 18-33
clear multiauth precedence 18-34
show multiauth port 18-34
set multiauth port 18-35
clear multiauth port 18-35
show multiauth station 18-36
show multiauth session 18-36
show multiauth idle-timeout 18-37
set multiauth idle-timeout 18-38
clear multiauth idle-timeout 18-39
show multiauth session-timeout 18-39
set multiauth session-timeout 18-40
clear multiauth session-timeout 18-41