Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 100 of 509
Mod. 0808 2011-07 Rev.2
+CMER - Mobile Equipment Event Reporting
<keyp> - keypad event reporting
0 - no keypad event reporting
<disp> - display event reporting
0 - no display event reporting
<ind> - indicator event reporting
0 - no indicator event reporting
2 - indicator event reporting
<bfr> - TA buffer clearing
0 - TA buffer of unsolicited result codes is cleared when <mode> 1..3 is entered
1 - TA buffer of unsolicited result codes is flushed to the TE when
<mode> 1...3 is entered (OK response shall be given before flushing
the codes)
Note: After AT+CMER has been switched on with e.g. AT+CMER=2,0,0,2
command (i.e. <bfr> is 0), URCs for all registered indicators will be issued
only first time, if previous <mode> was 0, for backward compatibility.
Values shown by the indicators will be current indicators values, not buffered
ones. Subsequent AT+CMER commands with <mode> different from 0 and
<bfr> equal to 0 will not flush the codes, even if <mode> was set again to 0
before. To flush the codes, <bfr> must be set to 1.
Although it is possible to issue the command when SIM PIN is pending, it will
answer ERROR if “message” or “smsfull” indicators are enabled in AT+CIND,
because with pending PIN it is not possible to give a correct indication about SMS
status. To issue the command when SIM PIN is pending you have to disable
“message” and “smsfull” indicators in AT+CIND first.
Read command returns the current setting of parameters, in the format:
+CMER: <mode>,<keyp>,<disp>,<ind>,<bfr>
Test command returns the range of supported values for parameters <mode>,
<keyp>, <disp>, <ind>, <bfr>, in the format:
+CMER: (list of supported <mode>s),(list of supported <keyp>s),
(list of supported <disp>s),(list of supported <ind>s),(list of supported <bfr>s)
Select Phonebook Memory Storage - +CPBS
+CPBS - Select Phonebook Memory Storage
<storage>[,<passw
ord>]
Set command selects phonebook memory storage <storage>, which will be used by
other phonebook commands.
To Next Page
Loading...
Need help?
General
