Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 76 of 509
Mod. 0808 2011-07 Rev.2
Change Facility Password - +CPWD
+CPWD - Change Facility Password
<oldpwd>, <newpwd>
Execution command changes the password for the facility lock function defined by
command Facility Lock +CLCK.
Parameters:
<fac> - facility
“SC” - SIM (PIN request)
“AB” - All barring services
“P2” - SIM PIN2
“PS”- SIM VO
<oldpwd> -
string type, it shall be the same as password specified for the facility
from the ME user interface or with command +CPWD.
<newpwd> - string type, it is the new password
Note: parameter <oldpwd> is the old password while <newpwd> is the new one.
Test command returns a list of pairs (<fac>,<pwdlength>) which presents the
available facilities and the maximum length of their password (<pwdlength>)
+CPWD: ("SC",8),("AB",4),("P2",8),("PS",8)
Calling Line Identification Presentation - +CLIP
+CLIP - Calling Line Identification Presentation
Set command enables/disables the presentation of the CLI (Calling Line Identity) at
the TE. This command refers to the GSM supplementary service CLIP (Calling
Line Identification Presentation) that enables a called subscriber to get the CLI of
the calling party when receiving a mobile terminated call.
Parameters:
<n>
0 - disables CLI indication (factory default)
1 - enables CLI indication
If enabled the device reports after each RING the response:
+CLIP: <number>,<t
ype>,””,128,<alpha>,<
CLI_validity>
where:
<number> - string type phone number of format specified by <type>
<type> - type of address octet in integer format
To Next Page
Loading...
Need help?
General
