Telit Wireless Solutions LE910 - Domain Configuration for Outgoing SMS - #ISMSCFG

Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 410 of 509
Mod. 0808 2011-07 Rev.2
Parameter:
<mode>
- MO SMS format
0 – 3GPP format
1 – 3GPP2 format (factory default)
<3GPP2PDUMode>
- 3GPP2 SMS PDU input format
0 – 3GPP-like format
1 – 3GPP2 format, according to Telit syntax: see +CMGS command
(factory default)
2 – 3GPP2 format, according to 3GPP2 C.S0015-A reference.
NOTE:
<3GPP2PDUMode>
setting works only if
+CMGF
is 0 and
<mode> is 1, otherwise it is ignored.
AT#SMSFORMAT?
Read command reports the current setting of parameter <mode>,
in the format:
#SMSFORMAT: <mode>,<3GPP2PDUMode>
(see above for details)
AT#SMSFORMAT=?
Test command returns the supported range of values for
parameter <mode> and <3GPP2PDUMode>.
Domain configuration for Outgoing SMS - #ISMSCFG
#ISMSCFG – Domain configuration for Outgoing SMS
SELINT 2
AT#ISMSCFG=<mode>
Set command changes the configuration parameter for outgoing SMS,
which will be used to route the outgoing SMS either over CPS or over
IMS (IP Multimedia Core Network Subsystem).
Parameter:
<mode>
0 - the SMS service is not to be invoked over the IP networks;
1 - the SMS service is preferred to be invoked over the IP networks
(default)
NOTE: the setting is saved in NVM.
AT#ISMSCFG?
Read command returns the current domain selected to route the
outgoing SMS in the format:
#ISMSCFG: <mode>