Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 261 of 509
Mod. 0808 2011-07 Rev.2
#PSMRI – Power Saving Mode Ring
Note: the behavior for #PSMRI is invoked, only when modem is in sleep mode
(AT+CFUN=5 and AT+CFUN=9)
Note: in case of AT+CFUN=9, the pulse is generated also when a GPRS packet is
received.
Note: the value set by command is stored in the profile extended section and
doesn’t depend on the specific AT instance
Read command reports the duration in ms of the pulse generated, in the
format:
Test command reports the supported range of values for parameter <x>
Control Command Flow - #CFLO
#CFLO – Command Flow Control
<enable>
Set command enables/disables the flow control in command mode. If enabled,
current flow control is applied to both data mode and command mode.
Parameter:
<enable> -
0 – disable flow control in command mode <default value>
1 – enable flow control in command mode
Note: setting value is saved in the profile
Read command returns current setting value in the format
#CFLO: <enable>
Test command returns the range of supported values for parameter <enable>
To Next Page
Loading...
Need help?
General
