Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 236 of 509
Mod. 0808 2011-07 Rev.2
SMS Overflow - #SMOV
[<mode>]
Set command enables/disables the SMS overflow signalling function.
Parameter:
<mode>
0 - disables SMS overflow signalling function (factory default)
1 - enables SMS overflow signalling function; when the maximum storage
capacity has been reached, the following network initiated notification is sent:
#SMOV: <memo>
where <memo> is a string indicating the SMS storage that has reached
maximum capacity:
“SM” – SIM Memory
Read command reports whether the SMS overflow signalling function is currently
enabled or not, in the format:
Test command returns the supported range of values of parameter <mode>.
Mailbox Numbers - #MBN
Execution command returns the mailbox numbers stored on SIM, if this service is
provided by the SIM.
The response format is:
[#MBN: <index>,<number>,<type>[,<text>][,mboxtype][<CR><LF>
#MBN: <index>,<number>,<type>[,<text>][,mboxtype][…]]]
where:
<index> - record number
<number> - string type mailbox number in the format <type>
<type> - type of mailbox number octet in integer format
129 - national numbering scheme
145 - international numbering scheme (contains the character "+")
<text> - the alphanumeric text associated to the number; used character set should
be the one selected with command +CSCS
<mboxtype> - the message waiting group type of the mailbox, if available:
"VOICE" - voice
"FAX" - fax
"EMAIL" - electronic mail
To Next Page
Loading...
Need help?
General
