Telit Wireless Solutions LE910 User Manual

Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 196 of 509
Mod. 0808 2011-07 Rev.2
#CEERNET – Ext error report for Network reject cause
SELINT 2
FEATURE NOT SUPPORTED(SM cause failure)
41
SEMANTIC ERROR IN TFT OPERATION
42
SYNTACTICAL ERROR IN TFT OPERATION
43
UNKNOWN PDP CNTXT
44
SEM ERR IN PKT FILTER
45
SYNT ERR IN PKT FILTER
46
PDP CNTXT WITHOUT TFT ACTIVATED
47
MULTICAST GROUP MEMBERSHIP TIMEOUT
48
RETRY ON NEW CELL BEGIN(if MM cause failure) /
ACTIVATION REJECTED BCM VIOLATION(if SM cause failure)
50
PDP TYPE IPV4 ONLY ALLOWED
51
PDP TYPE IPV6 ONLY ALLOWED
52
SINGLE ADDRESS BEARERS ONLY ALLOWED
63
RETRY ON NEW CELL END
81
INVALID TRANSACTION IDENTIFIER
95
SEMANTICALLY INCORRECT MESSAGE
96
INVALID MANDATORY INFORMATION
97
MSG TYPE NON EXISTENT OR NOT IMPLEMENTED
98
MSG TYPE NOT COMPATIBLE WITH PROTOCOL STATE
99
IE NON_EXISTENT OR NOT IMPLEMENTED
100
CONDITIONAL IE ERROR
101
MSG NOT COMPATIBLE WITH PROTOCOL STATE
111
PROTOCOL ERROR UNSPECIFIED
112
APN RESTRICTION VALUE INCOMPATIBLE WITH ACTIVE PDP CONTEXT
AT#CEERNET=?
Test command returns OK result code.
Reference
3GPP 24.008
Display PIN Counter - #PCT
#PCT - Display PIN Counter
SELINT 2
AT#PCT
Execution command reports the PIN/PUK or PIN2/PUK2 input remaining attempts,
depending on +CPIN requested password in the format:
#PCT: <n>
where:
<n> - remaining attempts
0 - the SIM is blocked.
1..3 - if the device is waiting either SIM PIN or SIM PIN2 to be given.
1..10 - if the device is waiting either SIM PUK or SIM PUK2 to be given.
AT#PCT=?
Test command returns the OK result code.

Telit Wireless Solutions LE910 Specifications

General

Brand	Telit Wireless Solutions
Model	LE910
Category	Control Unit
Language	English