Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 354 of 509
Mod. 0808 2011-07 Rev.2
Context activation and configuration extended - #SGACTCFGEXT
#SGACTCFGEXT - context activation configuration extended
<cid>,
<abortAttemptEnable>
[,<unused>
[,<unused>
[,<unused>
]]]
Execution command is used to enable new features related to
context activation.
Parameters:
<cid> - PDP context identifier (see +CGDCONT command)
1..5 - numeric parameter which specifies a particular PDP context definition
< abortAttemptEnable >
0 – old behaviour: no abort possible while attempting context activation
1 – abort during context activation attempt is possible by sending a byte on
the serial port.
It takes effect on successive GPRS context activation attempt through
#SGACT command in the following manner.
While waiting for AT#SGACT=<cid>,1 response(up to 150 s) is possible to
abort attempt by sending a byte and get back AT interface control(NO
CARRIER indication).
Note:
If we receive delayed CTXT ACTIVATION ACCEPT after abort, network
will be automatically informed of our aborted attempt through
relative protocol messages(SM STATUS) and will also close on
its side.
Otherwise, if no ACCEPT is received after abort, network will be informed
later of our PDP state through other protocol messages
(routing area update for instance).
Read command reports the state of all the five contexts, in the format:
#SGACTCFGEXT: <cid1>,< abortAttemptEnable1 >,0,0,0<CR><LF>
…
#SGACTCFGEXT: <cid5>,< abortAttemptEnable5 >,0,0,0<CR><LF>
where:
<cidn> - as <cid> before
< abortAttemptEnable n> - as < abortAttemptEnable > before
Note: values are automatically saved in NVM.
Test command reports supported range of values for all parameters
To Next Page
Loading...
Need help?
General
