Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 353 of 509
Mod. 0808 2011-07 Rev.2
1 - enable unsolicited result code, after an automatic activation/reactivation, of
the local IP address obtained from the network. It has meaning only if
<auto>=1. The unsolicited message is in the format:
#SGACT: <ip_address>
reporting the local IP address obtained from the network.
Note: the URC presentation mode <urcmode> is related to the current AT
instance only. Last <urcmode> setting is saved for every instance as extended
profile parameter, thus it is
possible to restore it even if the multiplexer control
channel is released and set up, back and forth.
Note: < retry > and <delay> setting are global parameter saved in NVM
Note: if the automatic activation is enabled on a context, then it is not allowed
to modify by the command AT#SCFG the association between the context
itself and the socket connection identifier; all the other parameters of
command AT#SCFG are modifiable while the socket is not connected
Read command reports the state of all the five contexts, in the format:
#SGACTCFG: <cid1>,<retry1>,<delay1>, < urcmode >CR><LF>
…
#SGACTCFG: <cid5>,<retry5>,<delay5>,< urcmode >
where:
<cidn> - as <cid> before
<retryn> - as <retry> before
<delayn> - as <delay> before
< urcmode > - as < urcmode > before
Test command reports supported range of values for parameters <cid>
>,<retry>,<delay>and < urcmode >
To Next Page
Loading...
Need help?
General
