Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 198 of 509
Mod. 0808 2011-07 Rev.2
Read command reports the current parameter settings for # EHNRST
command in the format:
# EHNRST: < mod >[,<delay>,<remainTime>]
<remainTime> - time remaining before next reset
Test command reports supported range of values for parameters <mod> and
<delay>.
…. Module reboots after 60 minutes …
AT#ENHRST=1,0
…. Module reboots now …
AT#ENHRST=2,60
…. Module reboots after 60 minutes and indefinitely after every following
power on …
Wake From Alarm Mode - #WAKE
#WAKE - Wake From Alarm Mode
[<opmode>]
Execution command stops any eventually present alarm activity and, if the module
is in alarm mode, it exits the alarm mode and enters the normal operating
mode.
Parameter:
<opmode> - operating mode
0 - normal operating mode; the module exits the alarm mode, enters the normal
operating mode, any alarm activity is stopped (e.g. alarm tone playing) and an
OK result code is returned.
Note: the alarm mode is indicated by status ON of hardware pin CTS and by status
ON of pin DSR; the power saving status is indicated by a CTS - OFF and DSR -
OFF status; the normal operating status is indicated by DSR - ON.
Note: during the alarm mode the device will not make any network scan and will
not register to any network and therefore is not able to dial or receive any call or
SM, the only commands that can be issued to the MODULE in this state are the
#WAKE and #SHDN, every other command must not be issued during this state.
To Next Page
Loading...
Need help?
General
