Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 93 of 509
Mod. 0808 2011-07 Rev.2
+CFUN - Set Phone Functionality
power save, then the module will wake up and proceed normally with the
unsolicited incoming call code
Note: when the module detects USB port is connected, then the power saving mode
is not allowed
Note: in CYCLIC SLEEP mode (AT+CFUN=7) CTS line toggles slowly, the
toggle delay is about 2 seconds
Note: in CYCLIC SLEEP mode (AT+CFUN=7) during incoming voice call the
CTS line continues to toggle
Note: if AT#ENS=1 then AT+CFUN=0 has the same functionality of
Read command reports the current setting of <fun>.
Test command returns the list of supported values for <fun> and <rst>.
Enter PIN - +CPIN
[,<newpin>]
Set command sends to the device a password which is necessary before it can be
operated (SIM PIN, SIM PUK, PH-SIM PIN, etc.).
If the PIN required is SIM PUK or SIM PUK2, the <newpin> is required. This
second pin, <newpin> will replace the old pin in the SIM.
The command may be used to change the SIM PIN by sending it with both
parameters <pin> and <newpin>
Parameters:
<pin> - string type value
<newpin> - string type value.
To check the status of the PIN request use the command AT+CPIN?
Read command reports the PIN/PUK/PUK2 request status of the device in the form:
+CPIN: <code>
where:
<code> - PIN/PUK/PUK2 request status code
READY - ME is not pending for any password
SIM PIN - ME is waiting SIM PIN to be given
SIM PUK - ME is waiting SIM PUK to be given
PH-SIM PIN - ME is waiting phone-to-SIM card password to be given
PH-FSIM PIN - ME is waiting phone-to-very first SIM card password to be
given
PH-FSIM PUK - ME is waiting phone-to-very first SIM card unblocking
password to be given
SIM PIN2 - ME is waiting SIM PIN2 to be given; this <code> is returned only
when the last executed command resulted in PIN2 authentication
failure (i.e. +CME ERROR: 17)
To Next Page
Loading...
Need help?
General
