Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 141 of 509
Mod. 0808 2011-07 Rev.2
supported<SDU error ratio>s),(list of supported<Residual bit error
ratio>s),(list of supported <Delivery of erroneous SDUs>s),(list of
supported <Transfer delay>s),(list of supported <Traffic handling
priority>s), (list of supported <Source statistics descriptor>s), (list of
supported <Signalling indication>s)
Note: only the “IP” PDP_Type is currently supported.
Parameter command syntax - +CGEQOS
+CGEQOS - parameter command syntax
[<cid>[,<QCI>
[,<DL_GBR>,
<UL_GBR>
MBR]]]]
+CME ERROR: <err>
The set command allows the TE to specify the EPS Quality of Service parameters
<cid>, <QCI
>, [<DL_GB
R> and
<UL_GBR>] and [<DL
_MBR> and <UL_
MBR>] for a PDP cont
ext or Traffic
Flows. When in UMTS/GPRS the MT
applies a mapping function to UTMS/GPRS Quality of Service. Refer subclause 9.2
for <err> values.
A special form of the set command, +CGEQOS= <cid> causes the values for context
number <cid> to become
undefined.
<cid>: a numeric parameter which specifies a particular EPS Traffic Flows definition
in EPS and a PDP Context
definition in UMTS/GPRS.
<QCI>: a numeric parameter that specifies a class of EPS QoS. (see 3GPP TS 23.203
[85])
0 QCI is selected by network
[1 – 4] value range for guranteed bit rate Traffic Flows
[5 – 9] value range for non-guarenteed bit rate Traffic Flows
<DL_GBR>: a numeric parameter which indicates DL GBR in case of GBR QCI.
The value is in kbit/s. This
parameter is omitted for a non-GBR QCI. (see 3GPP TS 24.301 [83])
<UL_GBR>: a numeric parameter which indicates UL GBR in case of GBR QCI.
The value is in kbit/s. This
parameter is omitted for a non-GBR QCI. (see 3GPP TS 24.301 [83])
<DL_MBR>: a numeric parameter which indicates DL MBR in case of GBR QCI.
The value is in kbit/s. This
parameter is omitted for a non-GBR QCI. (see 3GPP TS 24.301 [83])
<UL_MBR>: a numeric parameter which indicates UL MBR in case of GBR QCI.
The value is in kbit/s. This
parameter is omitted for a non-GBR QCI. (see 3GPP TS 24.301 [83])
The read command returns the current settings for each defined QoS.
+CGEQOS: <cid>, <QCI>,
To Next Page
Loading...
Need help?
General
