Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 435 of 509
Mod. 0808 2011-07 Rev.2
#STIA - SIM Toolkit Interface Activation
issued (see #STGI), and after the SAT main menu has been displayed on TE an
AT#STSR=37,0,x command is issued to select an item in the menu (see #STSR).
SIM Tookit Get Information - #STGI
#STGI - SIM Tookit Get Information
[<cmdType>]
#STGI set command is used to request the parameters of a proactive command
from the ME.
Parameter:
<cmdType> - proactive command ID according to GSM 11.14 (decimal); these
are only those command types that use the AT interface; SAT
commands which are not using the AT interface (not MMI related SAT
commands, e.g. PROVIDE LOCAL INFORMATION) are executed
without sending any indication to the user
1 - REFRESH
5 – SET UP EVENT LIST
16 - SET UP CALL
17 - SEND SS
18 - SEND USSD
19 - SEND SHORT MESSAGE
20 - SEND DTMF
32 - PLAY TONE
33 - DISPLAY TEXT
34 - GET INKEY
35 - GET INPUT
36 - SELECT ITEM
37 - SET UP MENU
40 – SET UP IDLE MODE TEXT
64 – OPEN CHANNEL
Requested command parameters are sent using an #STGI indication:
#STGI: <parameters>
where <parameters> depends upon the ongoing proactive command as follows:
if <cmdType>=1 (REFRESH)
#STGI: <cmdType>,<refresh type>
where:
<refresh type>
0 - SIM Initialization and Full File Change Notification;
1 - File Change Notification;
To Next Page
Loading...
Need help?
General
