Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 241 of 509
Mod. 0808 2011-07 Rev.2
and the deletion period, in the format:
#FPLMN: <action>,<period>
Test command reports available values for parameters <action> and
<period>.
Show Call Timers - #SCT
Execution command returns the value stored in USIM field Incoming Call
Timer, which contains the accumulated incoming call timer duration value
for the current call and previous calls, and the value stored in the USIM
field Outgoing Call Timer, that contains the accumulated outgoing call
timer duration value for the current call and previous calls, in the format:
#SCT: <ICT>,<OCT>
where:
<ICT> - Incoming Call Timer string, in the format: "hh:mm:ss", where
hh - hour
mm - minute
ss - seconds
<OCT> - Outgoing Call Timer string, in the format: "hh:mm:ss", where
hh - hour
mm - minute
ss - seconds
Test command returns the OK result code.
#Show Call Information - #SCI
#SCI – Show Call Information
Execution command returns the value stored in USIM field Incoming Call
Information, which contains the time of the call and duration of the last
calls, and the value stored in the USIM field Outgoing Call Information,
that contains time of the call and duration of the last calls, in the format:
To Next Page
Loading...
Need help?
General
