EasyManuals Logo

Telit Wireless Solutions LE910 User Manual

Telit Wireless Solutions LE910
509 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #476 background imageLoading...
Page #476 background image
Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 476 of 509
Mod. 0808 2011-07 Rev.2
OTA Set User Answer - #OTASUAN
#OTASUAN OTA Set User Answer
SELINT 2
AT#OTASUAN=
<response>[,<mode>[
,<bfr>]]
Set command:
a)
enables or disables sending of unsolicited result code #OTAEV that asks
the TE to accept or reject the Management Server request to download a
firmware
b) allows the TE to accept or reject the request
Parameters:
<response> - numeric parameter used to accept or reject the download request
0 – the request is rejected
1 – the request is accepted
2 – the request is delayed indefinitely: the URC is prompted indefinitely until the
request is accepted or reject
<mode> - numeric parameter that controls the processing of unsolicited result code
#OTAEV
0 –buffer unsolicited result codes in the MT; if MT result code buffers is full, the
oldest ones can be discarded. No codes are forwarded to the TE.
1 –discard unsolicited result codes when MT-TE link is reserved (e.g. in on-line
data mode); otherwise forward them directly to the TE
2 –buffer unsolicited result codes in the MT when MT-TE link is reserved (e.g. in
on-line data mode) and flush them to the TE when MT-TE link becomes
available; otherwise forward them directly to the TE
<bfr> - numeric parameter that controls the effect on buffered codes when <mode>
1 or 2 is entered
0 – MT buffer of unsolicited result codes #OTAEV is cleared when <mode> 1 or
2 is entered
1 – MT buffer of unsolicited result codes #OTAEV is flushed to TE when
<mode> 1 or 2 is entered
Note: the following unsolicited result codes and the corresponding events are
defined:
#OTAEV: Do you want to upgrade the firmware?
A management server request to start the firmware upgrade. The user answer is
expected
#OTAEV: User Answer Timeout
Expected User Answer not received within server defined time interval
#OTAEV: Automatic Fw Upgrade Requested
An automatic Fw Upgrade procedure has started
#OTAEV: Start Fw Download
The firmware download is started

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Telit Wireless Solutions LE910 and is the answer not in the manual?

Telit Wireless Solutions LE910 Specifications

General IconGeneral
BrandTelit Wireless Solutions
ModelLE910
CategoryControl Unit
LanguageEnglish

Related product manuals