Telit Wireless Solutions LE910 User Manual

Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 112 of 509
Mod. 0808 2011-07 Rev.2
<auxmode>:
1 yy/MM/dd (default)
2 yyyy/MM/dd
Note: The <time> format of +CCLK and +CALA is
"yy/MM/dd,hh:mm:ss+zz" when <auxmode>=1 and it is
"yyyy/MM/dd,hh:mm:ss+zz" when <auxmode>=2.
AT+CSDF?
Read command reports the currently selected <mode> and <auxmode> in
the format:
+CSDF: <mode>,<auxmode>
AT+CSDF=?
Test command reports the supported range of values for parameters
<mode> and <auxmode>
Setting time format - +CSTF
+CSTF – setting time format
SELINT 2
AT+CSTF=[<mode>]
This command sets the time format of the time information presented to
the user, which is specified by use of the <mode> parameter. The
<mode> affects the time format on the phone display and doesn't affect
the time format of
the AT command serial interface, so it not actually not used.
Parameters:
<mode>:
1 HH:MM (24 hour clock; default)
2 HH:MM a.m./p.m.
AT+CSTF?
Read command reports the currently selected <mode> in the format:
+CSTF: <mode>
AT+CSTF=?
Test command reports the supported range of values for parameter
<mode>

Telit Wireless Solutions LE910 Specifications

General

Brand	Telit Wireless Solutions
Model	LE910
Category	Control Unit
Language	English