Telit Wireless Solutions LE910 User Manual

Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 35 of 509
Mod. 0808 2011-07 Rev.2
Manufacturer Identification - +GMI
+GMI - Manufacturer Identification
SELINT 2
AT+GMI
Execution command returns the manufacturer identification.
Reference
V.25ter
Model Identification - +GMM
+GMM - Model Identification
SELINT 2
AT+GMM
Execution command returns the model identification.
Reference
V.25ter
Revision Identification - +GMR
+GMR - Revision Identification
SELINT 2
AT+GMR
Execution command returns the software revision identification.
Reference
V.25ter
Capabilities List - +GCAP
+GCAP - Capabilities List
SELINT 2
AT+GCAP
Execution command returns the equipment supported command set list.
Where:
+CGSM: GSM ETSI command set
+FCLASS: Fax command set
+MS: Mobile Specific command set
+ES: WCDMA data Service common modem command set
Reference
V.25ter
Serial Number - +GSN
+GSN - Serial Number
SELINT 2
AT+GSN
Execution command returns the device board serial number.
Note: The number returned is not the IMSI, it is only the board number
Reference
V.25ter

Telit Wireless Solutions LE910 Specifications

General

Brand	Telit Wireless Solutions
Model	LE910
Category	Control Unit
Language	English