Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 481 of 509
Mod. 0808 2011-07 Rev.2
Set IP Port and Address for OTA over IP - #OTASNAPIP
#OTASNAPIP – Set IP port and address for OTA over IP
<IPort>,<IPaddr>[,<
mynumber>[,<compa
ny_name>[,<unused>
]]]
Set command specifies the IP port number and IP address that the module has to use
to send the Remote Registration massage. If the current IMSI hasn’t been yet
registered, the Remote Registration message is automatically sent.
Parameters:
<IPort> - IP port of the OTA server
<IPaddr> - IP address of the OTA server, string type.
This parameter can be any valid IP address in the format: “xxx.xxx.xxx.xxx”
<mynumber> - string parameter which specifies the phone number of the client
<company_name> - string parameter containing a client identifier
Note1: the command returns ERROR if the APN has not been set through the
command AT#OTASNAPIPCFG
Note2: a special form of the Set command, #OTASNAP=<IPort>,””, sets the IP
address to “0.0.0.0”.
Note3: the values of <IPort> and <IPaddr> parameters can be overwritten from
the OTA server by any SMS ( Command, RSA Discovery Registration … )
Note4: a change of the value of <company_name> parameter causes a new FOTA
Registration procedure
Note5: if the <company_name> is an empty string, an ERROR is returned
Note6: all the settings are saved in NVM but < mynumber>
Read command reports the current settings in the format:
#OTASNAPIP: <IPort>,<IPaddr>[,<company_name>],0
Test command returns the range for <IPort> values and the maximum length of
<mynumber> field and <company_name> field. The format is:
#OTASNAPIP: (0-65535),,<nlength>,<tlength>
where:
<nlength> - integer type value indicating the maximum length of field
<mynumber>
<tlength> - integer type value indicating the maximum length of field
To Next Page
Loading...
