Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 482 of 509
Mod. 0808 2011-07 Rev.2
Set Access Point Name for OTA over IP - #OTASNAPIPCFG
#OTASNAPIPCFG – OTA Set Access Point Name for OTA over IP
G=
>[,<rspTimeout>]]
Set command specifies the bearer (GSM or GPRS) and the APN that the module
has to use to send the Remote Registration message.
The APN is the Access Point Name in case of GPRS bearer or the internet service
provider number in case of GSM bearer.
Parameters:
<bearer>
0 – Undefined ( default value )
1 – GSM
2 - GPRS
<APN> - string parameter; in case of GPRS bearer: Access Point Name, a logical
name t
hat is used to select the GGSN or the external packet data network;
in case of GSM bearer: phone number of the internet service provider
<username> - string parameter, used only if the context requires it
<password> - string parameter, used only if the context requires it
<rspTimeout> - used when waiting for a response from OTA server, after the
module has sent a message: if there’s no response within this timeout period the
TCP connection is closed.
0 - no timeout
1..65535 - timeout value in seconds (default 300 s.)
Note1: if the <bearer> is set to 0, then the APN is erased. If the bearer is already 0,
any <APN> or <username> or <password> will not be set
Note2: the values of <bearer>, <APN>, <username> and <password>
parameters can be overwritten from the OTA server by any SMS ( Command, RSA
Discovery Registration … )
Note3: all the settings are saved in NVM
G?
Read command reports the current settings in the format:
#OTASNAPIPCFG:
<bearer>,<APN>[,<username>[,<password>[,<rspTimeout>]]]
G =?
Test command returns the range for <bearer> values, the maximum length of
<APN>, <username> and <password> string parameters and the range for
<rspTimeout> values. The format is:
#OTASNAPIPCFG: (0-2),99,49,49,(0-65535)
To Next Page
Loading...
Need help?
General
