Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 111 of 509
Mod. 0808 2011-07 Rev.2
Execution command deletes an alarm in the ME
Parameter:
<n> - alarm index
Test command reports the range of supported values for <n> parameter.
Postpone alarm - +CAPD
+CAPD – postpone or dismiss an alarm
Set command postpones or dismisses a currently active alarm.
Parameters:
<sec
>: integer type value indicating the number of seconds to postpone the
alarm (maximum 60 seconds). If <sec> is set to 0 (default), the alarm is
dismissed.
Test command reports the supported range of values for parameter <sec>
Setting date format - +CSDF
+CSDF – setting date format
[,<auxmode>]]
This command sets the date format of the date information presented to
the user, which is specified by use of the <mode> parameter. The
<mode>
affects the date format on the phone display and doesn't affect the
date format of
the AT command serial interface, so it not used.
The command also sets the date format of the TE-TA interface, which is
specified by use of the <auxmode> parameter (i.e., the <auxmode>
affects the <time> of AT+CCLK and AT+CALA). If the parameters are
omitted then this sets the default value of <mode>.
Parameters:
<mode>:
1 DD-MMM-YYYY (default)
2 DD-MM-YY
3 MM/DD/YY
4 DD/MM/YY
5 DD.MM.YY
6 YYMMDD