EasyManuals Logo

Telit Wireless Solutions LE910 User Manual

Telit Wireless Solutions LE910
509 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #274 background imageLoading...
Page #274 background image
Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 274 of 509
Mod. 0808 2011-07 Rev.2
HSDPA Channel Quality Inication - #CQI
#CQI HSDPA Channel Quality Indication
AT#CQI
Execution command reports channel quality indication in the form:
#CQI: <cqi>
where
<cqi>
- cqi value
0 - 30
31 - not known or not detectable
Note: values are valid only if the module is registered on a WCDMA network
with HSDPA/HSUPA established. There will be no CQI if HSDPA/HSUPA is
not established.
AT#CQI=?
Test command returns the supported range of values of the parameters
<cqi>.
Note:
This command is not supported in LTE-only variants
Ciphering Indication - #CIPHIND
#CIPHINDCiphering Indication
SELINT 2
AT#CIPHIND =[<mode>]
Set command enables/disables unsolicited result code for cipher
indication. The ciphering indicator feature allows to detect that
ciphering is not switched on and to indicate this to the user. The
ciphering indicator feature may be disabled by the home network
operator setting data in the SIM/USIM. If this feature is not
disabled by the SIM/USIM, then whenever a connection is in place,
which is unenciphered, or changes from ciphered to unenciphered or
vice versa, an unsolicited indication shall be given to the user.
Parameter:
<mode>
0 - disable #CIPHIND unsolicited result code (factory default)
1 - enable #CIPHIND unsolicited result code
#CIPHIND: <mode>
AT#CIPHIND?
Read command reports the <mode>,<cipher> and <SIM/USIM flag>:
#CIPHIND: <mode>,<cipher>,<SIM/USIM flag>

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Telit Wireless Solutions LE910 and is the answer not in the manual?

Telit Wireless Solutions LE910 Specifications

General IconGeneral
BrandTelit Wireless Solutions
ModelLE910
CategoryControl Unit
LanguageEnglish

Related product manuals