Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 48 of 509
Mod. 0808 2011-07 Rev.2
Call Control
Dial - D
Execution command starts a call to the phone number given as parameter.
If “;” is present, a voice call to the given number is performed, regardless of the
current value of the connection mode set by +FCLASS command.
Parameter:
<number> - phone number to be dialed
Note: type of call (data or voice) depends on last +FCLASS setting.
Note: the numbers accepted are 0-9 and *,#,”A”, ”B”, ”C”, ”D”,”+”.
Note: for backwards compatibility with landline modems modifiers
“T”, ”P”, ”R”, ”,”, ”W”, “!”, “@” are accepted but have no effect.
Issues a call to phone number which corresponding alphanumeric field is <str>;
all available memories will be searched for the correct entry.
If “;” is present a voice call is performed.
Parameter:
<str> - alphanumeric field corresponding to phone number; it must be enclosed in
quotation marks.
Note: parameter <str> is case sensitive.
Note: used character set should be the one selected with +CSCS.
Issues a call to phone number in phonebook memory storage <mem>, entry
location <n> (available memories may be queried with AT+CPBS=?).
If “;” is present a voice call is performed.
Parameters:
<mem> - phonebook memory storage; it must not be enclosed in quotation marks.
SM - SIM phonebook
FD - SIM fixed dialing-phonebook
LD - SIM last-dialing-phonebook
MC - device missed (unanswered received) calls list
RC - ME received calls list
MB - mailbox numbers stored on SIM, if this service is provided by the SIM (see
#MBN).
<n> - entry location; it should be in the range of locations available in the memory