Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 49 of 509
Mod. 0808 2011-07 Rev.2
Issues a call to phone number in entry location <n> of the active phonebook
memory storage (see +CPBS).
If “;” is present a voice call is performed.
Parameter:
<n> - active phonebook memory storage entry location; it should be in the range
of locations available in the active phonebook memory storage.
Issues a call to the last number dialed.
Issues a call to the number stored in the MODULE internal phonebook position
number <nr>.
If “;” is present, a voice call is performed.
Parameter:
<nr> - internal phonebook position to be called (See commands &N and &Z)
ATD<number>i[;]
Issues a call overwriting the CLIR supplementary service subscription default
value for this call
If “;” is present a voice call is performed.
I - invocation, restrict CLI presentation
i - suppression, allow CLI presentation
ATD<number>g[;]
Issues a call checking the CUG supplementary service information for the current
call. Refer to +CCUG command.
If “;” is present a voice call is performed.
[*<addr>][*[<L2P>]
[*[<cid>]]]]#
This command is specific of GPRS functionality and causes the MT to perform
whatever actions are necessary to establish communication between the TE and
the external PDN.
Parameters:
<gprs_sc> - GPRS Service Code, a digit string (value 99) which identifies a
request to use the GPRS
<addr> - string that identifies the called party in the address space applicable to
the PDP.
<L2P> - a string which indicates the layer 2 protocol to be used. For
communications software that does not support arbitrary characters
in the dial string, the following numeric equivalents shall be used:
1 - PPP
<cid> - a digit which specifies a particular PDP context definition (see
Data only products do not start the call and command answer is ERROR if a voice
call is requested.
The escape sequence causes a closure of the link.
To dial a number in SIM phonebook entry 6:
ATD>SM6
OK
To have a voice call to the 6-th entry of active phonebook:
To Next Page
Loading...
Need help?
General
