Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 80 of 509
Mod. 0808 2011-07 Rev.2
+COLP – Connected Line Identification Presentation
2 - unknown (e.g. no network is present )
Note: This command issues a status request to the network, hence it may take a few
seconds to give the answer due to the time needed to exchange data with it.
Test command reports the range for the parameter <n>
Connected line identification restriction status - +COLR
+COLR – Connected Line Identification Restriction status
This command refers to the GSM/UMTS supplementary service COLR (Connected
Line Identification Restriction) that enables a called subscriber to restrict the
possibility of presentation of connected line identity (COL) to the calling party after
receiving a mobile terminated call. The command displays the status of the COL
presentation in the network. It has no effect on the execution of the supplementary
service COLR in the network.
Execution command triggers an interrogation of the activation status of the COLR
service according 3GPP TS 22.081 (given in <m>):
+COLR: <m>
where:
<m>: integer type (parameter shows the subscriber COLR service status
in the network)
0 COLR not provisioned
1 COLR provisioned
2 unknown (e.g. no network, etc.)
Activation, deactivation, registration and erasure of the supplementary service
COLR are not applicable.
Test command tests for command existence
To Next Page
Loading...
Need help?
General
