Telit Wireless Solutions LE910 User Manual

Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 70 of 509
Mod. 0808 2011-07 Rev.2
+CREG - Network Registration Report
SELINT 2
AT+CREG?
Read command reports the <mode> and <stat> parameter values in the format:
+CREG: <mode>,<stat>[,<Lac>,<Ci>[,<AcT>]]
Note: <Lac>, and <Ci> and <AcT> are reported only if <mode>=2 and the
mobile is registered on some network cell.
AT+CREG=?
Test command returns the range of supported <mode>
Example
AT
OK
at+creg?
+CREG: 0,2
OK
(the MODULE is in network searching state)
at+creg?
+CREG: 0,2
OK
at+creg?
+CREG: 0,2
OK
at+creg?
+CREG: 0,2
OK
at+creg?
+CREG: 0,1
OK
(the MODULE is registered)
at+creg?
+CREG: 0,1
OK
Reference
3GPP TS 27.007
Operator Selection - +COPS
+COPS - Operator Selection
SELINT 2
AT+COPS=
[<mode>
[,<format>
[,<oper>[,< AcT>]]]]
Set command forces an attempt to select and register the network operator.
<mode> parameter defines whether the operator selection is done automatically or
it is forced by this command to operator <oper>.
The operator <oper> shall be given in format <format>.
Parameters:
<mode>
0 - automatic choice (the parameter <oper> will be ignored) (factory default)
1 - manual choice (<oper> field shall be present)

Telit Wireless Solutions LE910 Specifications

General

Brand	Telit Wireless Solutions
Model	LE910
Category	Control Unit
Language	English