Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 81 of 509
Mod. 0808 2011-07 Rev.2
Call Forwarding Number And Conditions - +CCFC
+CCFC - Call Forwarding Number And Condition
<reason>,
<cmd>[,<number>[,<
type>[,<class>
[,,,<time>]]]
Execution command controls the call forwarding supplementary service.
Registration, erasure, activation, deactivation, and status query are supported.
Parameters:
<reason>
0 - unconditional
1 - mobile busy
2 - no reply
3 - not reachable
4 - all calls (not with query command)
5 - all conditional calls (not with query command)
<cmd>
0 - disable
1 - enable
2 - query status
3 - registration
4 - erasure
<number> - string type phone number of forwarding address in format specified
by <type> parameter
<type> - type of address octet in integer format :
129 - national numbering scheme
145 - international numbering scheme (contains the character "+")
<class> - sum of integers each representing a class of information which the
command refers to; default 7 (voice + data + fax)
1 - voice (telephony)
2 - data
4 - fax (facsimile services)
8 - short message service
16 - data circuit sync
32 - data circuit async
64 - dedicated packet access
128 - dedicated PAD access
<time> - time in seconds to wait before call is forwarded; it is valid only when
<reason> "no reply" is enabled (<cmd>=1) or queried (<cmd>=2)
1..30 - automatically rounded to a multiple of 5 seconds (default is 20)
Note: when <cmd>=2 and command successful, it returns:
+CCFC: <status>,<class1>[,<number>,<type>[,,,<time>]][<CR><LF>
+CCFC: <status>,<class2>[,<number>,<type>[,,,<time>]][ … ]]
To Next Page
Loading...
Need help?
General
