Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 253 of 509
Mod. 0808 2011-07 Rev.2
#GAUTH – PPP Data Connection Authentication Type
[<type>]
Set command sets the authentication type used in PDP Context Activation during
PPP-GPRS connections.
Parameter
<type>
0 - no authentication
1 - PAP authentication (factory default)
2 - CHAP authentication
Note: if the settings on the server side (the host application) of the PPP are not
compatible with the AT#GAUTH setting, then the PDP Context Activation will
use no authentication.
Read command reports the current authentication type, in the format:
Test command returns the range of supported values for parameter <type>.
PPP-GPRS Parameters Configuration - # GPPPCFG
#GPPPCFG - PPP-GPRS Parameters Configuration
<hostIPaddress>
[,<unused_A>]
[,<unused_B>]]
Set command sets one parameter for a PPP-GPRS connection.
Parameters:
<hostIPaddress> - Host IP Address that is assigned to the PPP server side (the
host application); Sstring type, it can be any valid IP address
in the format: xxx.xxx.xxx.xxx.
Note: if <hostIPaddress>=”000.000.000.000” (factory default) host address
is not included in the IPCP Conf Req, host address choice is
left to the peer
Read command reports the current PPP-GPRS connection parameters in the
format:
#GPPPCFG: <hostIPaddress>,,<unused_A>,<unused_B>
Test command returns the range of supported values for parameters
#GPPPCFG: (25),(0)
Skip Escape Sequence - #SKIPESC
To Next Page
Loading...
Need help?
General
