Telit LE910 V2 Series AT Commands
80446ST10707A Rev. 0– 2015-11-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 328 of 509
Mod. 0808 2011-07 Rev.2
#SGACT - Context Activation
Note: In LTE network, default PDP context(cid 1) is activated by
piggybacking on LTE attach procedure and maintained until detached from
NW. This command with cid 1 is just binding or unbinding application to the
default PDP context.
Returns the state of all the contexts that have been defined
#SGACT: <cid1>,<Stat1><CR><LF>
…
#SGACT: <cid5>,<Stat5>
where:
<cidn> - as <cid> before
<statn> - context status
0 - context deactivated
Test command reports the range for the parameters <cid> and <stat>
It is strongly recommended to use the same command (e.g. #SGACT) to activate
the context, deactivate it and interrogate about its status.
Socket Shutdown - #SH
This command is used to close a socket.
Parameter:
<connId> - socket connection identifier
1..6
Note: socket cannot be closed in states “resolving DNS” and “connecting”
( see AT#SS command )
Test command reports the range for parameter <connId>.
Socket Configuration - #SCFG
#SCFG - Socket Configuration
<connId>,<cid>,
<pktSz>,<maxTo>,
<connTo>,<txTo>
Set command sets the socket configuration parameters.
Parameters:
<connId> - socket connection identifier
1..6
<cid> - PDP context identifier
0 - specifies the GSM context
To Next Page
Loading...
Need help?
General
